Description
Geekvape J Empty Pod XL
The Geekvape J Empty Pod takes replaceable J Series coils (sold separately) and holds XL 5ml of e-liquid. Fits the Digi Max and Digi Pro pod kits through a magnetic connection. Four coil resistances work with this pod: 0.4, 0.6, 0.8, and 1.2 ohm, covering RDL and MTL. When the coil’s done you just swap the coil, not the whole pod, which brings the running cost down. Sold in packs of two.Top airflow sits above the e-liquid line with Geekvape’s triple leak-proof build. An adjustable airflow ring on the pod controls the draw tightness. Top-fill with a silicone seal. Works with nic salts and 50/50 e-liquids. Key Features XL capacity
Takes J Series coils: 0.4, 0.6, 0.8, 1.2 ohm (sold separately)
Digi Max and Digi Pro compatible
Triple leak-proof design with top airflow
Adjustable airflow ring for MTL and RDL
Top-fill with silicone seal
Magnetic pod connection
Swap coils, keep the pod – lower running cost
Nic salt and 50/50 e-liquid compatible
2-pack J Coil Resistance Guide
Coils push-fit into the base of the empty pod. All four J Series resistances are compatible: Resistance
Wattage
Style
Best With 0.4 ohm
23-28W
RDL
50/50 or slightly higher VG 0.6 ohm
18-25W
RDL / loose MTL
50/50 e-liquids 0.8 ohm
12-18W
MTL
Nic salts, 50/50 1.2 ohm
8-12W
Tight MTL
Nic salts (10-20mg) Lower resistance coils at higher wattages will go through e-liquid faster, so the 5ml capacity is particularly handy on the 0.4 and 0.6 ohm coils. The 0.8 and 1.2 ohm coils sip liquid at their lower wattages, so the pod lasts longer between refills. How to Change the Coil
Pull the old coil out of the pod base. Push the new J coil in until it seats. Prime it by dropping a few spots of e-liquid onto the cotton, fill the pod through the top-fill port, then wait 5 minutes for the cotton to soak. The pod itself lasts through multiple coil changes. J Empty Pod vs J Pod J Empty Pod
J Pod Coil
Replaceable J coil (sold separately)
Built-in, discard whole pod Running cost
Lower – swap coil only
Higher – replace full pod Setup
Push coil in, prime, fill
Fill and go Best for
Cost saving over time
Convenience, no coil changes Geekvape J Empty Pod Specifications Spec
Detail Model
Geekvape J Series Empty Pod Pack Size
2 pods Capacity
XL 5ml / 2ml (TPD) Coil Compatibility
J Series Coils 0.4, 0.6, 0.8, 1.2 ohm Coil Installation
Push-fit into pod base Fill System
Top-fill, silicone seal Airflow
Top, adjustable ring Leak Prevention
Triple leak-proof Connection
Magnetic Vaping Style
MTL, RDL E-liquid
Nic salts, 50/50 e-liquids Device Compatibility
Digi Max, Digi Pro What’s in the Box? 2 x Geekvape J Series Empty Replacement Pods (XL 5ml)
