Description
SMOK RGC Replacement Coils | Mesh, MTL & Rebuildable
All three RGC parts SMOK makes for the RPM80 platform – a conical mesh for direct lung, a dual-coil MTL, and a rebuildable deck that arrives with a coil already installed.
HighlightsThree options: 0.17ohm Conical Mesh, 0.6ohm DC MTL and the RGC RBA Coil KitThe RBA kit ships with a Clapton coil pre-installed plus screwdriver, screws and o-ringsMTL and mesh cover both ends of the draw range on one deviceSold as a single coil or a 5-pack
RGC Coil Specs
CoilResistanceWattageDrawConical Mesh0.17ohm40-80WDTLDC MTL0.6ohm8-16WMTLRBA Coil Kit0.6ohm pre-installedSet by your buildSet by your build
SMOK’s own coil chart lists exactly these three RGC parts but publishes no wattage for any of them. The one official figure is that the 0.17ohm conical mesh supports power as high as 80W on the RPM80, RPM80 Pro and Fetch Pro – and all three of those are 80W devices, so that ceiling is the device cap rather than a coil rating. The 40-80W and 8-16W bands are distributor consensus. The RBA has no rated wattage at all, because it is a rebuildable deck and the power depends on the coil you install; the only hard number SMOK gives is a 0.25ohm minimum build resistance. MTL on the 0.6ohm is SMOK’s own label. The RBA’s pre-built Clapton is the only RGC part with a published wire alloy (nichrome with ferrochrome).
Compatible With
SMOK Fetch Pro Kit (Fetch Pro RGC Pod), RPM80 Kit and RPM80 Pro Kit (RPM80 RGC Pod). Despite some retailer listings, RGC coils are not SMOK-listed for the RPM40, the Fetch Mini or the Nord 2.
Why Shop SMOK at Central Vapors
The RBA option turns an RPM80 into a rebuildable without a second device, so we stock it alongside the drop-in coils rather than treating it as a specialty item. Central Vapors has been filling vape orders since 2013, and every order is backed by our satisfaction guarantee.
Common Questions
QWhat is the difference between the DC MTL coil and the RBA kit?The DC MTL is a fixed, drop-in coil. The RBA is a rebuildable deck that arrives with a Clapton coil already installed so you can vape it straight away, then rebuild it yourself later.QWhich option should I pick for direct-lung vaping?The 0.17ohm Conical Mesh, which distributors rate 40-80W.QWhat wattage do I run the RBA at?There is no rated figure – it depends on the coil you build. SMOK’s only published limit is that the build must not go below 0.25ohm.QDo these fit the RPM40 or a Nord 2?No. Some retailers list them that way, but SMOK’s own chart covers only the Fetch Pro, RPM80 and RPM80 Pro. The RPM40 and Fetch Mini take RPM coils instead.QIs there a 0.3ohm RGC coil?Not in SMOK’s official RGC roster. A few retailers have listed one as coming soon; we stock only the three parts SMOK actually publishes.
For use by adults 21+.
