Description
SMOK LP1 Replacement Coils The SMOK LP1 coil is the original coil deck for the Novo 4, Novo 4 Mini, NFIX Pro, RPM 25W, and Pozz Pro kits. Triple silicone rings give it a press-fit install with a leak-resistant seal, and the lineup runs from a wide-open 0.8ohm mesh build down to a tight 1.2ohm mesh build for nic salts. Highlights 5 resistance builds from 0.8ohm to 1.2ohm Meshed and DC MTL coil types in one lineup Triple silicone ring, press-fit install Sold as a 5 Pack LP1 Coil Specs CoilResistanceTypeRecommended Wattage LP1 Dual MTL 0.8ohm DC MTL 12-25W LP1 Meshed 0.8ohm Mesh MTL 12W LP1 Meshed MTL 0.9ohm Mesh MTL Not separately published by SMOK LP1 TURBO Meshed MTL 0.9ohm Mesh MTL 17W LP1 Meshed 1.2ohm Mesh MTL 10-15W If your box or pod is labeled TURBO, order the 0.9ohm TURBO coil above for the correct fit – the standard (non-TURBO) 0.9ohm Meshed MTL coil uses the same resistance but an earlier core, and SMOK hasn’t published a separate wattage spec for it. Compatible With Novo 4 Kit, Novo 4 Mini Kit, Novo 4 Pods, Novo 4 Mini Pods, NFIX Pro Kit, RPM 25W, Pozz Pro Kit Common Questions Q What’s the difference between the 0.9ohm and 0.9ohm TURBO Meshed MTL coils? Both are mesh builds at the same resistance; the TURBO version is SMOK’s updated core with a recommended 17W setting. If your pod’s box says TURBO, order the TURBO coil for the intended fit. Q Which LP1 coil is best for nic salts? The 0.8ohm and 1.2ohm Meshed builds run in the 10-15W range, the typical sweet spot for nic salt e-liquid – a tight, warm MTL draw without over-driving the coil. Q Will LP1 coils fit my NFIX Pro or Pozz Pro? Yes. SMOK uses the same LP1 coil deck across the Novo 4, Novo 4 Mini, NFIX Pro, RPM 25W, and Pozz Pro kits. Q How long should an LP1 coil last? It depends on how much you vape and which e-liquid you use – sweeter, darker e-liquids tend to gunk up a coil faster. Most vapers get one to two weeks out of a coil before flavor noticeably drops off. For use by adults 21+.
